|
|
|
|
|
DOS ERROR MESSAGES
|
| Code | Meaning and Comments |
|---|---|
| 01 | Invalid Function number. Program made an invalid function call. |
| 02 | File Not Found. File does not exist or cannot be opened. |
| 03 | Path Not Found. Referenced Directory does not exist. |
| 04 | Out of File Handles (too many open files-no open handles left).Not enough FILES in CONFIG.SYS or network config. |
| 05 | Access Denied. File/Data locked or no rights to file on network. |
| 06 | Invalid handle program. Used a file handle which is not open. |
| 07 | Memory Corrupt (memory control blocks destroyed). DOS memory chain is corrupt. Possible software corrupted chain or hardware failure. |
| 08 | Insufficient Memory |
| 09 | Invalid Memory Block Address. Program tried to use an invalid memory block. |
| A(10) | Invalid Environment |
| B(11) | Invalid Format |
| C(12) | Invalid Access Code |
| D(13) | Invalid Data |
| E(14) | Reserved - Unused |
| F(15) | Invalid Disk Drive. Drive letter does not exist. |
| 10(16) | Attempt to Remove Current Directory. |
| 11(17) | Not the Same Device. Attempt to rename a file to a different drive. |
| 12(18) | No More Files. DOS Find Next function done. Not an error. |
| 13(19) | Disk Write-Protected. Some networks allow network drives to be write-protected. |
| 14(20) | Unknown Unit. Program tried to use a unit number that does not exist. |
| 15(21) | Drive Not Ready. No disk in drive. Possible hardware failure. |
|
|